• Conférence
  • Ingénierie & Outils numériques

Designed interfaces in adhesively bonded aluminium sandwich structures with 3D-printed polymer cores

Conférence : Communications orales sans actes dans un congrès international ou national

This study investigates the development of lightweight aluminium–polymer sandwich structures for aeronautical drilling applications, with particular emphasis on the mechanical performance of adhesively bonded interfaces. The sandwich structures consist of aluminium skins bonded to a 3D-printed polyethylene terephthalate glycol (PETG) core using a two-part structural epoxy adhesive. The polymer core architecture was first optimized using a Taguchi L9 experimental design, considering infill pattern, infill density, and number of walls. Three-point bending tests led to the selection of a honeycomb structure with 10% infill density and two walls, providing a favorable compromise between mechanical performance and weight. The study then focused on improving the skin–core interface through geometrical interlocking features directly integrated into the 3D-printed polymer core. Four interface geometries (dovetail, T-slot, bulb groove, and stepped) were investigated and compared with a non-textured reference configuration. Mechanical performance was evaluated through progressive loading–unloading cycles under three-point bending. Results demonstrate that interface geometry significantly influences both maximum load capacity and residual deformation. Bulb-groove and dovetail interfaces achieved maximum loads of approximately 4.9 kN and 4.7 kN, respectively, compared with 4.0 kN for the non-textured reference. The bulb-groove configuration also exhibited delayed residual deformation accumulation, demonstrating the benefits of mechanical interlocking for improving the structural performance of adhesively bonded aluminium–polymer sandwich structures.